Car charger IP65 12V/4A - 12V/0,8A Victron Energy

CCS connectorDepending on the application, clamps, eyelet terminals or a cigar socket can be connected to the charger (all included in the package).Less maintenance and less ageing when the battery is not in use: the storage modeThe storage mode is activated when the battery is not discharged for 24 consecutive hours. In this case the trickle voltage is reduced to 13.2 V to minimise gas formation and corrosion of the positive plates. The voltage is restored to the \"absorption\" level once a week to balance the state of charge of the battery. This process prevents electrolyte stratification and sulphation, the main causes of premature battery aging.Overheating and reverse polarity protectionIf the temperature exceeds 40°C, the output current is reduced but the charger continues to operate.The output relay provides protection against reverse polarity connections.Five status and active mode LEDsWhen the AC power is connected the STAND-BY LED lights up. In this situation there is still no voltage on the output.After connection to a battery (whose voltage is higher than 8.5 V), you can use the MODE button to choose one of the three charging profiles listed below.1. Current limited to 0.8 A and absorption voltage of 14.4 V. The red <14Ah LED lights up.2. Current of 4 A and absorption voltage of 14.4 V. The red LED lights up >14Ah.Application: Liquid electrolyte, AGM or GEL batteries. Ambient temperature 10-35°C.3. Current of 4A and absorption voltage of 14,7V. Application:Liquid electrolyte, AGM or GEL batteries. Ambient temperature below 10°C, or batteries that require a higher charging voltage (e.g. OPTIMA spiral-cell batteries).Until the battery is fully charged, the red CHARGE LED remains lit.When the charging process is complete, the red FULL LED lights up.In case of reverse polarity connection, the red ! If the STANDBY LED stays on even after pressing the MODE button, the connection to the battery is broken.When connected to AC power, the charger always turns on in STANDBY mode.